Jet DC-1100A, Руководство пользователя

Страница: 9 / 15

9
Assembly
1. Install four casters to the under side of the
base as pictured in Fig. 1. Thread the hex
nut (B, Fig. 1) onto the caster shaft. Then
slide the lock washer (A, Fig. 1) over the
caster shaft. Thread the caster shaft into
the threaded hole on the underside of the
base, turn until snug. Tighten the nut (B,
Fig. 1) against the base with a 9/16” or
14mm wrench. This will give the caster
proper clearance.
2. Place the base with casters on the ground.
Attach the motor and fan assembly (A, Fig.
2) to the base using four M8 x 16 hex cap
bolts, four M8 flat washers (B, Fig. 2), and a
1/2" or 13mm wrench.
WARNING
The dust collector must be disconnected
from the power source during assembly.
Failure to comply may result in serious
injury!
3. Attach inlet guard (A, Fig. 3) to fan housing
using eight M5 x 12 pan head screws (B,
Fig. 3). Press the inlet ports onto the inlet
guard until it snaps into place.
WARNING
To reduce the risk of injury from moving
parts, always keep inlet ports covered with
the caps provided, if they are not
connected to a flexible hose. Failure to
comply may result in serious injury!