Jet DC-1100A, Руководство пользователя

Страница: 11 / 15

11
7. Slide the bag hanger hook (A, Fig. 7)
through the top loop of the filter bag. Insert
the hanger into the hanger bracket. Thread
the retainer strap (B, Fig. 7) through the
loops on the filter bag (C, Fig.7), and fasten
to the collector housing. The retainer strap
should be tight enough to provide a good
seal.
8. Insert the ring (A, Fig. 8) of the collector bag
into the bottom of the housing at an angle.
Pull down on the bag to make sure it “seats”
in the housing.
Electrical Connections
WARNING
All electrical connections must be done by a
qualified electrician. All adjustments or
repairs must be done with the dust collector
disconnected from the power source,
unplugged. Failure to comply may result in
serious injury!
The DC-1100A dust collector is rated at
115/230V, Prewired 115V. Use a plug and
outlet rated at least 20 amps. The circuit for the
machine should also be protected by at least a
20 amp circuit breaker or fuse. Keep in mind
that a curcuit being used by other machines,
tools, lights, heaters, etc. at the same time will
add to the electrical load. A dedicated curcuit to
the dust collector will give you the best results
since dust collectors are generally used at the
same time other tools are running.
Before hooking up to the power source, make
sure that the switch is in the off position.
Turning the Machine On & Off
Before hooking up to the power source, make
sure that the switch is in the off position.
The dust collector can be turned on by pressing
the start button found on the motor. Press the
stop button to turn off the dust collector.