Jet AB-1012W, Инструкция по эксплуатации и каталог запасных частей

Страница: 7 / 52

7
6.0 Unpacking
Finish uncrating the Band Saw and check for
shipping damage. Report any damage immediately
to your distributor and shipping agent. Do not
discard any shipping material until the Band Saw is
assembled and running properly.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Read the instruction manual thoroughly
for assembly, maintenance and safety instructions.
6.1 Contents of Shipping Container
1 Band Saw (not shown)
1 Roller Table, 6-1/2 ft, with guides (A)
1 Chip Cart (B )
2 Bundle Clamps (C)
1 Can of Hydraulic Oil (D)
1 Tool Box (E) containing:
6 Leveling Bolts with Hex Nuts (F)
6 Foot Pads (G)
1 Hex (Allen) Wrench set (H)
1 Open End Wrench Set (J)
1 Cross-point (Phillips) Screwdriver (K)
1 Flat Head Screwdriver (L)
1 Adjustable Wrench (M)
1 Grease Gun (N)
1 Test Cut (O)
1 Inverter Instruction Booklet with CD (P)
1 Operating and Parts Manual (not shown)
1 Warranty Card (not shown)
Figure 1
Read and understand the entire contents of this manual before attempting set-up or
operation! Failure to comply may cause serious injury.