Jet 725000, Руководство по эксплуатации

Страница: 20 / 44

20
3. Use 3mm hex key to loosen two socket head
button screws (C, Figure 8-7). This will allow
the clamp plate (D) to slide back and forth on
the fixed base.
Slide clamp plate (D) toward or away from saw
blade as required. Attempt to make the gaps
as even as possible.
4. Tighten screws (C).
5. Reinsert riving knife; engage lever (A) and
check that saw blade/knife gap is between 3 to
8mm (Figure 8-8).
Figure 8-8
8.4 Table to blade alignment
Refer to Figures 8-9 and 8-10.
The table has been set square with the blade by
the manufacturer and no adjustment is necessary
now. As the saw receives extensive use, however,
table/blade squareness should be checked and
corrected if necessary. Use the miter slot to do this:
1. Disconnect machine from power source.
2. Raise blade to maximum height.
3. Mark one tooth (A) with a grease pencil and
position the tooth slightly above top edge of
table at the front.
Figure 8-9
4. Raise the miter gauge slightly out of its slot to
serve as a shoulder. Place a sliding square (B)
against side of miter bar, slide the scale over
until it touches the tip of blade, and lock the
scale in position. See Figure 8-9.
5. Rotate marked tooth (A) so that it is slightly
above table top at the rear and, using the
square as before, verify that the distance to
the blade is the same. See Figure 8-10. If the
distances are not the same, make a careful
note of the difference.
Figure 8-10
6. Slightly loosen the three mounting screws
(#10, sect. 14.2.1) that hold the table to the
stand; two in front, one in back.
7. Nudge table to bring miter slot in line with
blade.
8. Retighten mounting screws firmly.
9. Verify the alignment, angle pointer setting,
fence setting, etc. Make any further
adjustments as needed.
8.5 Belt adjustment/replacement
To adjust tension of drive belt:
1. Disconnect machine from power source.
2. Loosen bolt (C, Figure 8-11) in motor bracket
slot. If needed, also slightly loosen hex nut on
opposite side of motor bracket.
3. Shift motor as needed, downward to tighten
belt, upward to loosen.
4. Retighten bolt (and hex nut).
Figure 8-11