Jet 725000, Руководство по эксплуатации

Страница: 18 / 44

18
7.3 Extension cords
The use of extension cords is discouraged. Try to
position machines within reach of the power
source. If an extension cord must be used, make
sure it is heavy enough to carry the current your
product will draw. An undersized cord will cause a
drop in line voltage resulting in loss of power and
overheating. Table 3 shows correct size to use
depending on cord length and nameplate ampere
rating. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
Ampere
Rating
Volts Total length of cord in feet
More
Than
Not
More
Than
120
240 25
50 50
100 100
200 150
300
AWG
0 0 0 6 18 16 16 14
0 6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12
Not
Recommended
Extension Cord Recommendations
Table 3
7.4 On/off switch lock-out
The Table Saw is equipped with a push-button
switch that will accept a safety padlock, as shown
in Figure 7-3. To safeguard your machine from
unauthorized operation and accidental starting by
young children, the use of a padlock (not included)
is highly recommended. Place the key in a location
that is inaccessible to children and others not
qualified to use the tool.
Figure 7-3
8.0 Adjustments
8.1 Blade raising/tilt mechanism
Never try to force the tilting
mechanism past the 45º or 90º stops. This may
cause blade misalignment.
See Figure 8-1.
To raise or lower blade, loosen lock knob (A) and
turn handwheel (B) on front of saw until desired
height is reached. Tighten lock knob. The blade
should be adjusted about 1/8" above the top
surface of the material being cut.
To tilt blade, turn lock handle (C) counterclockwise
to loosen, turn handwheel (D) until desired angle is
obtained, then tighten lock handle (C) clockwise.
Figure 8-1
8.2 Adjusting blade tilt stops
The 45° and 90° blade tilt stops have been set by
the manufacturer, but should be verified by the
operator.
1. Disconnect machine from power source.
2. Raise blade to maximum height.
3. Set blade 90º to table by turning blade tilting
handwheel (D, Figure 8-1) counterclockwise
as far as it will go. Do not force beyond stop.
4. Place a square on the table and verify that
blade is at 90º to table. See Figure 8-2. Make
sure square is flat against blade surface and
not touching a blade tooth.
Figure 8-2
If adjustment is required:
5. Remove motor cover on left side.
6. Back out the setscrew in the 90° stop collar (E,
Figure 8-3), and position collar to allow further
movement of shaft bracket.
7. Turn blade tilting handwheel until blade is
exactly 90º.
8. Turn stop collar until it contacts shaft bracket,
and tighten set screw (E).