Jet 708315BTA, Инструкция по эксплуатации и каталог запасных частей

Страница: 26 / 84

26
Figure 39
Safety Devices
Feath
e
r Board
The feather board (Figure 40) should be made
of straight grain hardwood approximately 1" thick
and 4" to 8" wide depending on the size of the
machine. The length is developed in accordance
with intended use. Feather boards can be
fastened to the table or rip fence by use of
C-clamps. If this method of fastening is used,
provide slots in the feather board for adjustment.
(The illustration shows a method of attaching
and use of the feather board as a vertical comb.
The horizontal application is essentially the
same except that the attachment is to the table
top.)
Figure 40
Push Stick
A push stick is provided with this saw and
should be used as an added level of safety for
the operator.
Filler Piece
A filler piece (Figure 41) is necessary for narrow
ripping and permits the blade guard to remain on
the machine. It also provides space for the safe
use of a push stick.
Figure 41 – Filler Piece
Maintenance
Always disconnect power to
the machine before performing maintenance.
Failure to do this may result in serious
personal injury.
Cleaning
Clean the 708315 Table Saw according to the
schedule below to ensure maximum
performance.
Note: The following maintenance schedule
assumes the saw is being used every day.
Daily:
‰
Clean pitch and resin from the saw blade.
Weekly:
‰
Clean motor housing with compressed air.
‰
Wipe down the table surface, grooves and
fence rails with a dry silicon lubricant.