Jet-tech X-33, Руководство пользователя

Страница: 11 / 16

Trouble Shooting
Power is turned on but nothing happens!
> verify the circuit breaker in the building's electrical box. If the unit was installed with a cord and
plug, verify that the plug is well placed in the receptacle.
The power is on but the unit will not fill!
> verify that the incoming water shut off valve is opened.
The power is on, the unit is filled with water but it wont start!
> Verify that the door is properly closed.
The Unit is not cleaning!
> Verify the filter inside the wash tank area, it must be cleaned daily. Verify that all chemical
bottles are filled and there is no air gap in the chemical tubes. If there is an air gap in the tube, the
chemical pump should be primed. See instruction on page 9.
The temperature is too low (below 120F)!
>Verify your hot water supply. The hot water tank may be defective and can not supply hot water
to the dishwasher.
The water is overflowing out by the door!
> Verify that the drain hose is not kinked.
If you have tried the recommended action above and the problem remains, call for service.
If the following conditions happen, call for service.
The wash cycle is too long (more than 90 seconds).
The unit is not rinsing the glasses.
The unit will not shut off.
IMPORTANT NOTES
Locate and clearly identify the water shut-off valve that supplies the dishwasher and the fuse box or
breaker switches.
Only qualified and/or licensed technicians can repair this piece of equipment.
Removing panels will expose wires and live current. The breaker switch should be switched off or fuses
removed before removing the panels. The water supply must also be turned off.
CONTACT INFORMATION
Phone:
1-888-275-4538
514-737-9701
Fax:
514-737-2792
www.jet-tech.com
service@jet-tech.com
Phone:
Fax:
1-888-275-4538
514-737-9701
514-737-2792
www.jet-tech.com
service@jet-tech.com
11