Jet EQUIPMENT & TOOLS JLP Series, Руководство пользователя, Страница: 5 / 22

Model Number JLP-600-5, JLP-600-20
Stock Number .....................................................................................................187719 (5’), 187720 (20’)
Load Chain Diameter .......................................................................................................................10mm
Number of Falls .......................................................................................................................................2
Rated Capacity .................................................................................................................................6 Ton
Minimum Distance Between Hooks ...............................................................................................24-7/16”
Standard Lift ............................................................................................5’ (JLP-600-5), 20’ (JLP-600-20)
Lbs. Pull to Lift Capacity ........................................................................................................................76
Lever Length................................................................................................................................... 16-18”
Net Weight........................................................................................................... 66 lbs. (5’), 111 lbs. (20)
The specifications in this manual are given as general information and are not binding. JET Equipment
and Tools reserves the right to effect, at any time and without prior notice, changes or alterations to
parts, fittings, and accessory equipment deemed necessary for any reason whatsoever.
Prior to Operation
1. Support for the hoist may be hook, clevis
pin, trolley, or beam clamp. Whatever
method of suspension is chosen, the
support components must be rated equal to,
or greater than the capacity of the chain
hoist.
2. With the lever in the up position, check for a
clicking sound when the handle is rotated in
a clockwise direction. Do not use if this
sound is not present.
3. With the lever in the up position, check free
play in handle rotation. Free play is
measured by the distance the handle travels
before resistance or gearing is felt. If free
play has reached 3/4 of a turn, brake discs
are worn and should be replaced by a JET
authorized repair station.
4. If the puller has not been used for an
extended period of time, check for proper
operation before putting into service. Apply
a light coat of 30W oil to the chain.
5. The brake mechanism must be kept clean
and free from dirt, water, and oil. Never
allow oil to penetrate the braking
mechanism. Always keep your puller clean
and store in a clean, dry location.
6. It is not necessary to oil the chain. However,
a periodic coating of 30W oil will cause
easier operation and prolong the life of the
chain.
7. Check the chain for damage. Replace
damaged chain before using the puller.
WARNING
The load chain supplied with your JET puller
is designed, manufactured, and tested
for proper fit and durability. Over a
period of time, the chain may need to be
replaced. For your own safety, use
factory replacement chain only. Use of
other than factory replacement chain
may cause serious injury and/or damage
to the puller.
8. The top and bottom hooks on your JET
puller are designed to open and warn of an
overload. It is important to check top and
bottom hooks for proper opening. If the
safety latch no longer contacts the hook
opening, replace the hook. Never side load
the top or bottom hook; this practice is
dangerous and could lead to serious
injury.
9. If the vertical angle, at the neck, of the
bottom or top hook reaches 10
°
, replace the
hook, (Fig. 1).