Jet EQUIPMENT & TOOLS JLP Series, Руководство пользователя, Страница: 3 / 22

WARNING
•
Read and understand the entire contents
of this manual before attempting to use
the puller.
•
This puller is designed and intended for
use by properly trained and experienced
personnel only. If you are not familiar
with the proper and safe use of a puller,
do not use until proper training and
knowledge have been obtained.
•
Do not use to lift people or loads over
people.
•
Do not exceed the rated capacity of the
puller.
•
Do not use a “cheater pipe” to extend the
length of the puller handle.
•
Do not strike the handle with a hammer or
any other object.
•
Do not use puller chain as a sling. This may
cause damage to the chain.
•
Always inspect the puller for damage prior
to use. If puller is damaged, do not use until
it has been repaired or replaced.
•
Do not use more than one puller to lift or
move a load. If this is unavoidable, each
puller must have the same capacity as the
load to be moved.
•
Never allow chain to “set” over sharp edges.
All pulls or lifts must be made with straight
chain that is free of obstacles.
•
If the puller lever is difficult to operate, then
the load exceeds the capacity of the puller.
Select a puller of larger capacity.
•
Do not use a puller if the chain is twisted,
kinked or damaged.
•
Do not operate puller unless load is
centered between top and bottom hooks.
•
Always take time to study the job to be
performed and choose the safest method.
Do not place yourself or other people in an
unsafe position.
•
Leave all internal maintenance and
inspections to a qualified JET repair station.
•
Replace chain with factory replacement
chain only. Do not use any other type of
chain.
•
Never use the puller if either hook is
stretched, deformed, or has a broken or
missing safety latch. Always replace the
safety latch and/or the hook before placing
the puller back in service.
•
Understand and follow all procedures as set
forth in American National Standards titled
“Performance Standard for Manually Lever
Operated Chain Hoists”. ANSI/ASME HST-
3M. This standard is available through the
American Society of Mechanical Engineers,
345 East 47th St., NY, NY 10017
•
Failure to comply with all of these warnings
may cause serious injury and/or damage to
property.