9
Verify
that
the
overflow
device
is
completely removed and no obstructions are
present
in
the drain line.
ACTIONS FOLLOW
ING
WARNINGS:
Booster and tank heating elements
are interrupted, all loads are d
e
activated,
the electronic board displays warning codes
and is deactivated. All control panel LEDs
are Off. Cycle is interrupted “hold mode”
until the machine is reset. It is always
possible to turn appliance Off and On using
the button.
SAFETY THERMOSTAT
All machines are provided with a safety
overload that shuts machine off in case of
overheating (120°C/248°F). To reset the
overload device press the push-button behind
the control panel.
2D – DETERGENT AND RINSE AID
DISPENSERS AND SETTINGS
N.B.
This machine must be operated with an
automatic detergent feeder and, if
applicable, an automatic chemical sanitizer
feeder, including a visual means to verify
that detergents and sanitizers are delivered
or a visual or audible alarm to signal if
detergents and sanitizers are not available
for delivery to the respective washing and
sanitizing systems. Please see instructions
for electrical and plumbing connections
located in this manual and in the feeder
equipment manual.
Before starting a new cycle the dispenser and
its
tube
must
be
completely
filled.
Check the level
of
the
detergent
or
rinse aid and if needed fill-up the tank.
N.B.
The level in the detergent or rinse aid tank
must n
ever be
empty or filled with
corrosive or i
ncorrect
product. The
warranty does not cover damages caused
by improper use of
the
dispenser. The
dispenser is calibrated at
the
manufacturer
's
site
.
D
ispenser settings
after installation must be performed by
a qualified technician.
1-
Remove the front panel with Allen
key
or
similar tool by inserting it inside the
holes
on the interior part of the panel.
Remove
the panel carefully.
2-
For Hoodtype models, unscrew the two
screws located on the bottom of the
panel. (Fig.7)
Fig.7
Before removing the front panel make sure the
machine is disconnected from the main breaker.
3- Insert the dispenser tube inside
the detergent or rinse aid tank. (if
available). (Fig.8)
Fig.8
2D1 – PERISTALTIC RINSE AID AND
DETERGENT DISPENSER
The s
etting of rinse aid dispenser is
perfo
r
med by adjusting the screw
which is
accessible after removal of
the
front panel
under the tank door. (see Fig.8)
1- Gently Close the dispenser by screwing
the needle valve of the dispenser counter
clockwise.
2-
Open by screwing the needle valve of the
dispenser clockwise until the necessary
quantity has been achieved. (Fig.9)
Fig.9
Quantity for the first setting should be
done
by
the installer after evaluating the
hardness of the water and the type of rinse aid
used. Recommended rinse aid standard quantity
is
0,
0056oz
/sec
that
correspond
s
to
the
maximum
flow
rate
of
the
dispenser. Recommended detergent
standard
quantity is 0,
027oz
/sec that correspond
s
to
the maximum
flow rate of the dispenser.
SUGGESTION
To check the effectiveness of the rinse aid,
look at freshly washed glasses against the
light. Drops of water remaining on the glass
indicate an insufficient amount while streaks
indicate an excess.
In
the
case of
a
light coating that stop
s
the
dispenser function, remove the coating by
soaking the dishes for 30 minutes in a water
soap solution (1:10) before starting machine
cycle.
