Step 21
: Once you have your table upright
on the floor, you have one final adjustment.
With the 3/16” hex key loosen a ¼ turn the
(10) ten 5/16-18 Flat Head Cap Screws you
tightened in Step 4.
Retighten
.
(See Figure #18)
Note:
these screws line your carriage and
gear box to the table.
Step 20
: With the help of another person, flip
the Excel II and Stand over and place on the
floor.
Step 16
: Repeat this for all four carriage clamping
blocks
STEP 17
: With the ¼” hex key provided, loosen
the clamping screw sufficiently to force the
carriage to spread. This allows the router to be
installed easily. (See Figure #16)
Figure 16
Step 19
: Rotate the router so that when the final
installation is made all router controls are
positioned for convenient access an there is no
interference. Then back the motor off approx.
1/16” from contacting the table top and tighten the
cap screw on the carriage assembly.
(See Figure #17)
Figure 17
TAB-LOC PHENOLIC INSERT RINGS
Your Mast-R-Lift Excel II comes with one 2”
insert ring with a pre-drilled center hole.
Additional ring sets are available with different
diameter pre-drilled holes and/or no pre-drilled
holes for creating your own custom center
hole diameters. See your JessEm distributor
for these and other accessories.
Figure 18
Step 18:
Now slide the router motor into the
carriage so the top of the motor housing just
makes contact with the inside surface of the center
hole in the table top.
