
3. Next, take out the front assembly from Step 1,
and the left and right top braces (Part #1). Using
four ¼” washers and four ¼”-20 x 3/8” Stainless
Steel Cap Screws, mount the upper side braces to
the front assembly. The flanges on each brace
should be mounted facing up and inward.
Repeat this process for the left and right bottom
braces (part #7), again using four of the 1/4”-20 x
3/8” stainless steel cap screws (part #4) and four
1/4” stainless steel washers (part #2).
All screws should still be slightly loose at this point.
4. Take the rear leg and brace assembly from Step 2
and use the remaining eight 1/4”- 20 x 3/8”
stainless steel cap screws (part #4) and eight 1/4”
stainless steel washers (part #2) to enclose the
stand. Once this is complete all bolts on the stand
can be tightened securely with a 3/16” hex key. Do
not over tighten the screws.
5. If mounting a table top to the stand, leave the
top screws loose until the table top has been
mounted. Then tighten all screws.
Figure #1
Item #
Part #
Description
QTY.
1
S0090-1-C
Upper Side Brace
2
2
F0348
1/4” O.D. x 5/8” I.D. Stainless Steel Washer
32
3
S0090-1-C
Upper Front and Back Braces
2
4
F0559
¼”-20 x 3/8” Stainless Steel Cap Screws
32
5
S0090-1-C
Legs
4
6
S0090-1-C
Lower Back Brace
1
7
S0090-1-C
Lower Side Braces
2
8
S0090-1-C
Lower Front Brace (With JessEm Logo)
1