
Steel Router Stand
User Manual
Model #05150
324 Desbrisay Avenue
Moncton, New Brunswick,
E1E 0G8, Canada
Toll Free: 800-436-6799
Local Phone: 705-726-8233
Fax: 705-327-0295
Email: [email protected]
Website: www. JessEm.com
Tools Required: 3/16” Hex Key (Provided)
Thank you for choosing this product from JessEm
Tool Company. We appreciate your support and
hope that our product serves you well. This product
is designed to provide many years of reliable service
provided it is used as intended and taken care of.
This user manual will assist you in assembly and
general operation of this product. It is not our intent
to teach you about woodworking. It is assumed that
you are an experienced woodworker with the basic
skills and experience necessary to use this product
safely. If after reading the following instructions you
are unsure or uncomfortable about safely using this
product, we urge you to seek additional information
through widely available woodworking books or
classes.
As part of our Continuous Product Improvement
Policy, JessEm products are always advancing in
design and function. Therefore, there may be
differences between what is shown in our catalogs,
website or at retail display and what is sold at time
of purchase. We reserve the right to make positive
changes to our products at our discretion.
Assembly Instructions
1.
Place two legs (part #5) on a flat surface with the
castor holes facing out on either side (see Figure #3)
and the leveling feet closest to you. Take the front
lower brace (Part #8) and align it with the
corresponding holes as seen in figure #3, ensuring the
flange is oriented correctly. Using four ¼” Washers
and four ¼”-20 x 3/8” Stainless steel Cap Screws (parts
#2 and #4), loosely attach this brace to both legs. Do
not fully tighten the screws at this point. All screws
will be left loose until the entire stand is built.
Repeat this procedure to mount an upper brace to
both legs (part #3), using the same mounting
hardware as before. At this point you should have one
side assembled, as seen in figure #3.
2. Take the two remaining legs and again lay them in
front of you as done in Step 1. Build the rear leg and
brace assembly the same way as done in Step 1, again
leaving the screws slightly loose.