INSTALLATION INSTRUCTIONS
DL-FLEX2-TILE
Instruction sheet subject to
change without prior notice
Rev 59
3/12/2020
Page 2 of 6
INSTALLATION
1. Configure design and layout of the system before attempting to install this product. Do not exceed the maximum
ambient temperature of 113 degrees F. For dry location use only.
Note –
For dimming applications refer to the spec sheet and the wiring diagrams below.
2.
Turn off electricity
Before beginning installation, switch circuit breaker off or remove fuse.
3.
Determine location to install components
Refer to
WIRING DIAGRAMS
4.
Prepare FLEXTILE for installation
Cut the FLEXTILE LED sheet to desired lengths as required for your application. Only cut the LED strips along the
designated cut lines (dotted lines) as shown. Cutting anywhere else will damage the LED light strip.
Note –
FLEXTILE can be cut horizontally, vertically and at an angle.
5.
Mount the FLEXTILE LED sheet
OPTION 1: Using the adhesive film at the back
Clean the mounting surface. Remove backing on the flexible tape to expose adhesive (ensure ambient temperature
is minimum 50
degrees F for proper adhesion). Carefully press FLEXTILE to the mounting surface. Avoid pressing
on the LEDs or any electrical component, avoid using excessive force and avoid pinching. When bending tighter
than a 1” radius, do so only at the cut mark.
