4.3 The deposition is faulty
•
The electrolyte is contaminated.
- Replace the electrolyte, but first fill the electrolyte tank with distilled water clean
thoroughly with water.
•
The voltage (volts) has been set incorrectly
- The respective voltage specification can be found in the product description of the
pen bath
•
It was electroplated too long on the same spot without absorbing new electrolyte
- Pick up electrolyte with the felt and pass it evenly over the fabric
5. Cleaning instructions
The Picco+ is maintenance-free. Every now and then, the plating pins should be cleaned and
the felts replaced. To clean the pen, remove the tip,rinse the front part of the pen well with
normal water and rinse with distilled water. A new tip is then inserted. Parts that have already
been degreased should never be stored unprocessed for a longer period of time in order to
avoid staining and oxidation.
6. Safety instructions
When using electrical equipment, observe the following basic safety precautions to protect
against electric shock, injury, and fire. Read and observe these instructions before using the
device!
6.1 Keep your work area in order!
6.2 Take environmental influences into account!
6.3 Keep children away!
6.4 Check your device for damage!
6.5 Do not misuse the power cord!
6.6 Care for the device with care!
6.7 Only use the correct accessories!
7. Technical data
Housing: painted high quality steel
Dimensions (WxDxH): 120 x 150 x 95 mm
Rectifier: 12V/ 1.5A
Supply voltage: 230V/ 50Hz
Equipment: 1 pin (anode)
1 terminal (cathode)
5 felts
If you need assistance with the commissioning of the device, please contact us. You can reach
us by phone from 8:30am-4:30pm at +497231-418094-0 or email us at [email protected] with
your request.
For more information, click here:
Jentner Plating Technology GmbH
Johann-Staib-Strasse 2
75179 Pforzheim - Germany
Tel.: +497231 - 41 80 94-0
E-mail: [email protected]
Store: www.shop.jentner.de/en
