Commercial Scoop Slide Instructions
Support Brackets are optional, and not included. Must be purchased separately.
5.
(If not using support brackets, please skip this step.)
Remove the bracket head(s) from the
support pipe(s). Install the bracket head(s) onto the slide. Tighten and check bolts.
6.
Turn the slide over and lift into place.
There are four predrilled mounting holes on the top piece to fasten the slide to the
platform. This may be accomplished with lag screws or through bolts.
It is recommended to predrill the holes to avoid splitting the wood of the platform.
7.
(If not using support brackets, please skip this step.)
Raise the bottom of the slide approx.
6” off the ground, and thread the support pipe onto the bracket heads. Remove the block
and place the slide back onto the ground. Adjust the support bracket to firmly press
against the ground. Anchor the support bracket to the ground.
(Anchors not included)
8.
Recheck all bolts and connections, and retighten if necessary.
Congratulations! Your new slide is ready for use.
Support Bracket Locations
SC2 – 2’
First insert from
bottom of slide
SC4 – 4’
Third insert from
bottom of slide
SC6 – 6’
Fifth insert from
bottom of slide
