Commercial Scoop Slide Instructions
1.
Install alignment plugs onto the top, middle, and bottom pieces. Lay the slide components
face down on a flat surface.
2.
Starting from the top piece, insert the four bolts through the joining sections.
Tighten all four bolts evenly.
Note: It is recommended to use thread locker on the bolts to ensure the connections
will not loosen up over time.
3.
Repeat Step 2 across all of the inserts. When you are ready to join the bottom piece, you
will need to raise the slide in order to properly align the two sections.
4.
Check all of the bolts and retighten if needed.
Alignment Plugs
Bottom piece
Middle Pieces
(Inserts)
Top Piece
