E-6
POWER SOURCE (AC ADAPTOR ONLY)
The QiCR-200 operates with an external AC-DC adaptor with output
DC 5V
3A
.
The unit is also equipped with a battery back-up system for the clock that is powered
by 2 x AAA batteries (Not included).
POWER CONNECTION
1. Connect the cord of the power adaptor to the DC IN JACK (#20) of the QiCR-
200.
2. Connect the plug of the power adaptor to a wall socket.
The QiCR-200 is powered and in standby mode when you see the display is
switched on.
Battery Back-up system
•
The radio is equipped with a battery back-up system. It requires 2 x AAA
batteries (Not included).
•
Open the BATTERY DOOR (#23). Insert the batteries into the battery
compartment and make sure the positive and negative (+ or -) sides of the
batteries are in contact with the corresponding terminals in the battery
compartment. Replace the BATTERY DOOR (#23).
•
If a power cut occurs, the radio automatically switches to the battery power
supply and keeps the clock and timer settings.
•
When replacing the battery, do not disconnect the power adaptor. Otherwise, all
clock and alarm settings will be lost.
CAUTIONS:
1. Do not mix old and new batteries.
2. Only use good quality/name brand batteries.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
4. If the unit is not going to be used for an extended period of time, please remove
the batteries. Using old, leaking or cheaply made batteries can cause damage
to the unit and may void the warranty.
5. Do not dispose of batteries in fire, batteries may explode or leak.
6. Batteries shall not be exposed to excessive heat such as sunshine, fire or the
like.
7. Replace all the batteries at the same time, no matter exhausted or not, every 2
years at the same time to avoid possible battery leakage.
8. Do not try to recharge batteries not intended to be recharged; they can
overheat, rupture and leak. (Follow battery manufacturer's directions).
9. Only an adult should replace the batteries.
