E-11
Power Saver Mode
If the JSBW-750 is sitting idle, and no input signals are being received for 60
minutes, the unit will automatically switch to Standby mode to save energy.
NOTE:
Please note that a low volume setting from the audio source may be recognized as
“no audio signal”: this will affect the capability of signal detection from the device
and can also originate an automatic switch into standby mode. If this happens
please reactivate the audio signal transmission or increase the volume setting on
the audio source player (MP3 player, etc.), in order to resume playback. Please
contact the local service center if the problem remains.
USB CHARGING PORT
This unit features a USB JACK (for 1A USB charging) (#14) your portable device
(iPod, iPhone, Android phone, etc.) when used with the USB charging cord that
came with your device.
1. Plug one end of the USB cable (not included) into the USB JACK (for 1A USB
charging) (#14) located on the side of the unit. Plug the other end of the cord
into the device you wish to charge.
2. Observe the battery charge indicator on your device to make sure the
charging process starts normally.
3. Unplug the cable when your device is fully charged.
CAUTION:
Before charging, please refer to the user manual of the device you wish to charge
to make sure the charging current requested does not exceed 1A (1000mA).
Overloading the charging circuit may damage the unit permanently and void the
warranty.
1. The USB charging port of this unit supplies a DC 5V output at 1000mA
maximum current to charge your smart phone or portable device battery and it
cannot support
any other voltage range.
2. Make sure the device you want to charge has a battery charge rating of DC 5V
only.
3. The
USB port of this unit is designed for smart phone or portable device battery
charging only and it cannot support data transfer or connect to computer.
4. Do not connect the USB port of this unit to other external power charger
USB
ports, it may damage both units and void the warranty.
Note:
1. Some smart phones and portable devices use proprietary USB connections
and circuitry, so they may not charge when plugged into the USB port.
Please refer to your device user manual before you attempt to charge them.
2. It is normal if the unit gets warm while the USB port is in use and charging
your smart phone or portable device.
3. Do not charge your smart phone over 12 hours continuously. Disconnect
your smart phone or other portable device from the USB cord once it is fully
charged.
