1.
Turn on the unit and press
the
function selector to switch to RADIO mode. The Power ON/OFF
indicator and RADIO indicator will
light
to show the unit is
in
Radio mode.
2.
FM stations can be auto scanned by pressing
the
Radio scan button.
Press the button again to
advance to the next station
.
3.
Once you reach th end of the FM band, press the
rest button
to restart the scanning from the beginning.
Note: To obtain the best FM radio reception, fully extend the FM antenna wire located on the back
of the unit.
If you are using
an
iPod without a docking port or other MP3/digital audio player, you can still play it on
the JiSS-20 via
the
AUX IN jack.
1.
Turn on the unit and press
the
function selector to switch to AUX mode. The Power ON/OFF indicator
and AUX indicator will
light
to show the unit is
in
AUX mode.
2.
Plug one end of the 3.5mm audio cable (included) into the headphone or Line out jack on your
player. Plug the other end of the cable into the unit AUX IN jack located on the back of the JiSS-20.
3.
Turn on the player.
4.
Use the volume up/down buttons on the
JiSS-20
to adjust the
main
volume. You may need to adjust
your
player
volume if it is connected
via the
headphone jack of your audio device.
To use the remote control, please ensure the remote control battery CR2025 (included) is installed
properly.
Replace the remote control battery when it stops working. It is highly recommended to use a good
quality Lithium cell.
Note:
!
The battery isolat
or
paper
must
be removed
prior to use
.
!
R
oom
lighting and
battery life can affect the operating range of the remote control.
LISTENING TO THE FM RADIO
LISTENING TO A NON-DOCKING iPod
OR OTHER
DIGITAL AUDIO DEVICE
REMOTE CONTROL
6