5
batteries at the same time as soon as possible to avoid battery leakage.
B. AC Adaptor Operation
1. Insert one end of the AC adaptor into the DC
Jack on back of JiMS-182.
2. Connect the AC plug of the AC adaptor to an
AC 120V~ 60Hz power source.
Note: The batteries will be automatically disconnected when the AC adaptor is plugged
into the DC Jack and the System will operate on AC power.
Note:
Unplug the AC adaptor and disconnect the DC Jack when the JiMS-182 is
not in use for a long period of time.
C. ACTIVATING THE BACKUP FUNCTION
To activate the backup function of the system remove the Battery Insulation Tag
from the backup battery compartment.
Replacing the Lithium Battery
1. Remove the battery tray located on the back of the unit.
2. Replace the exhausted “CR2025” 3V lithium battery with a
new one with the “+” side facing upward.
3. Slide the battery tray back into the unit.
IMPORTANT:
Be sure that the battery is installed correctly.
Wrong polarity may damage the unit and void the warranty.
Tilting the Speaker Body up or down
The speaker body can be lifted up to face forward at about a
45 degree angle. Press down on the two Release Buttons
located on both sides of the main body to lay the speaker
body down flat.
SETTING THE CURRENT TIME
Current Time Setting
When first plugged in the display will show “12:00” after power up. The following
example shows the procedure for setting the clock time to 8:20 AM.
1. The dock display will show “12:00” when first plugged in.