10
Stopping the Alarm
The alarm is programmed to continuously sound for 60 minutes. To stop the alarm,
follow the directions below.
1.
SNOOZE / DIMMER
Button – Press this button to stop the alarm temporarily.
The alarm will stop and automatically resume after 9 minutes.
2.
POWER/
STANDBY
Button – Press this Button to stop the alarm which will
sound again 24 hours later.
3.
ALM.1 / MEM-
or
ALM.2 / MEM+
Button – Press this Button once to stop the
alarm and the alarm will sound again 24 hours later.
DIMMER Operation (With AC Adaptor plugged in)
In power off mode, press the
SNOOZE / DIMMER
Button repeatedly to adjust the
LCD backlight to low, middle or high as desired.
Note:
i.
With the AC Adaptor plugged in and with power off, press any button except
SNOOZE/DIMMER
and the LCD backlight will automatically set to high and
resume to the preset brightness in approximately 5 seconds.
ii.
If using battery power, the LCD backlit is always set to the dimmest
level in order to conserve battery power. Press any button the LCD
backlight will automatically set to high and resume to the dimmest level
in approximately 5 seconds.
Turning the Lamp On/Off
1. You can press the
LIGHT
button to turn the
Lamp
on and off.
2. The
Lamp
will also light automatically one minute before the alarm time is
reached and increase to the full brightest level when the alarm time is reached.
3. When you stop the alarm by pressing the
SNOOZE/DIMMER
,
POWER
,
ALM.1/MEM-
or
ALM.2/MEM+
Button, the
Lamp
will be turned off at the same
time. You can also press the
LIGHT
Button to turn off the
Lamp
directly.
4. If
the
Lamp
is on before waking to alarm, radio or iPod, when you stop the
alarm by pressing the
SNOOZE/DIMMER
, POWER/
STANDBY
,
ALM.1/MEM-
or
ALM.2/MEM+
Buttons, the
Lamp
will remain on. To turn the
Lamp
off press
the
LIGHT
Button once.
SLEEP OPERATION
Your JiMS-182 can be programmed to turn off according to your preset sleep time.
The sleep time can be set for 15, 30, 60, 90 or 120 minutes.
