AUXILIARY INPUT
This unit provides an auxiliary audio signal input jack for connecting external audio devices like
MP3 players, CD players and listen to them through the speaker of this unit.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on either ends.
2. Plug one end into the AUX IN JACK on the main unit and the other end of the cable into the
Line-out Jack or Headphone Jack of your external audio device.
3. Turn “On” the unit and external audio device.
4. Press MODE button on the unit repeatedly until ”AU” appeared on LED DISPLAY.
5. The volume level can now be controlled through the main unit. Operate all other functions on the
external device as usual.
CARE AND MAINTENANCE
•
Children should be supervised when using this appliance.
•
Never wrap the AC POWER CORD around any animal or person. Special care should be taken
with long wire.
•
Avoid operating your unit under direct sunlight or in hot, humid or dusty places.
•
Keep your unit away from heating appliances and sources of electrical noise such as fluorescent
lamps or motors.
•
Unplug the unit from the electrical power outlet immediately in case of malfunction.
GB - 9
NAP FUNCTION
Notes:
•
If you connect this unit to the Line Out Jack of your external device then you only need to adjust
the volume control of this unit. If you connect the Headphone Jack of your external device then
you may need to adjust both the volume controls of your external device and this unit to obtain
the desirable volume setting.
•
Press and hold the
button to turn off the unit when you have finished listening. Don’t forget to
switch off the power of your external device as well.
DIMMER CONTROL
Press the
DIMMER
button to change the LED DISPLAY brightness between high or low in
accordance with normal or dim indoor lighting conditions.
This function wakes you up after a short period of time. Only the beeper alarm sound can be
selected.
1. In standby mode, tap the NAP button repeatedly to select 120, 90, 60, 30, 15, 10 or 5 minutes for
your nap, wait 5 seconds for the unit to confirm your selection. The NAP indicator lights up.
2. To stop the NAP alarm when it sounds, press the NAP or
button.
3. To cancel NAP alarm before sounding, tap the NAP button repeatedly until display shows “OFF”
and wait for 5 seconds to confirm.
