E-7
SETTING THE CLOCK TIME
In order for the clock to function properly
,
the clock has to be set before you use it for
the first time. After powering up the unit or press and hold PRESET/TIME Button (#7)
at standby mode, the clock display will flash. To set the time, follow the steps below:
1.
Tap the TUN-/HR/
/ TUN+/MIN/
Buttons (#3/#4) until the correct time is
displayed..
2. Press the PRESET/TIME Button (#7) to confirm the time.
Note:
Make sure the hour is set so that AM or PM is correctly displayed. There is a PM
INDICATOR (#14) located in the upper left corner of the LED display. If the PM
INDICATOR (#14) is showing on the display, the displayed time is “PM”. If the PM
INDICATOR (#14) is not showing on the display, the time displayed is “AM”.
RADIO OPERATION
Press the MODE / Button (#6) repeatedly to Turn On the unit and select AM/FM
Mode, frequency will show on the LED display.
Press and hold the TUN-/HR/
Button (#3) OR TUN+/MIN/
Button (#4) to search
for the next / previous available station. If the reception is poor, try Manual Tuning to
fine-tune the station. Tap the TUN-/HR/
Button (#3) OR TUN+/MIN/
Button (#4)
briefly to manually tune through the frequency band.
Adjust the /- Control (#9/10) to obtain the desired sound level.
The LED display will change to show the clock time after a few seconds. Press the
TUN-/HR/
OR TUN+/MIN/
Buttons (#3/4) to check the tuned frequency.
Setting the Radio Station Presets
The unit allows you to store up to
30 FM s
tations and 30 AM stations for easy recall
at any time.
1.
Press the POWER / Button (#6) repeatedly to Turn On the unit and select
AM/FM Mode.
2. Tune to the radio station you want to store in memory.
3.
Press and hold the PRESET/TIME Button (#7). The preset channel number “P01”
will be flashing on display
.
4. To change the preset channel number location, p
ress the TUN-/HR/
OR
TUN+/MIN/
Buttons (#3/4) to step through the preset locations ( P01 – P30 ).
5. To confirm the preset location, press
PRESET/TIME Button (#7).
6.
To store up to 30 station presets, repeat steps 2-5 above.
RECALL PRESET STATION
In AM/FM mode, press PRESET/TIME Button (#7) repeatedly to select the preset
channel.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak, change the
position of the unit until the internal antenna picks up the strongest signal.
FM - If FM reception is weak, fully extend the wire antenna and vary the position and
location of the antenna until you find the strongest signal.
