E-5
POWER SOURCE
This unit is designed to operate on AC 120V~ 60Hz. Operating this unit on any other
power source may cause damage to the unit, and such damage is not covered by
your warranty.
It is also equipped with a battery back-up system for the clock that is powered by 2 X
AA (UM-3) batteries (not included).
BATTERY BACK-UP SYSTEM
The Battery Back-up System ensures the clock and alarm settings will be retained
during a power interruption or power outage (in order to preserve the battery life the
Display will not light). All clock settings will be kept in memory, however, the clock
time may require adjustment for exact accuracy once the power returns. If the
batteries are not installed, the Display will blink”12:00” when the power is restored.
This will indicate that you have to reset the time and alarm settings.
BATTERY INSTALLATION
1. Open the battery compartment door on the bottom of the cabinet.
2. Follow the polarity diagram shown inside the compartment and Install 2 X “AA”
size batteries (not included).
3. Replace the Battery Compartment Door.
IMPORTANT:
Be sure that the batteries are installed correctly. Wrong polarity may
damage the unit.
NOTE:
Only use a well-known brand of battery to ensure longest life and the best
performance.
CAUTIONS:
1.
Do not mix old and new batteries.
2.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
3.
If the unit is not to be used for an extended period of time, remove the batteries.
Old or leaking batteries can cause damage to the unit and may void the
warranty.
4.
Do not dispose of batteries in fire, batteries may explode or leak.
5.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the
like.
6.
Replace all the batteries at the same time, no matter exhausted or not, every 2
years at the same time to avoid possible battery leakage.
7.
Do not try to recharge batteries not intended to be recharged; they can overheat,
rupture and leak. (Follow battery manufacturer's directions).
8.
Only an adult should replace the batteries.
POWER FAILURE INDICATOR
If there are no batteries installed in the unit or the batteries installed are weak or
dead, the time and alarm settings will be lost if the power is interrupted. When the
AC power is restored the display will flash “12:00”. This indicates that the time
displayed is incorrect and needs to be reset.
IMPORTANT:
After you reset the time, be sure to reset your alarm settings as well.
