Jensen JCR-160, Руководство пользователя

Страница: 8 / 14

E-7
CAUTIONS:
1. Do not mix old and new batteries.
2. Only use good quality/name brand batteries.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
4. If the unit is not going to be used for an extended period of time, please remove
the batteries. Using old, leaking or cheaply made batteries can cause damage to
the unit and may void the warranty.
5. Do not dispose of batteries in fire, batteries may explode or leak.
6. Batteries shall not be exposed to excessive heat such as sunshine, fire or the
like.
7. Replace all the batteries at the same time, no matter exhausted or not, every 2
years at the same time to avoid possible battery leakage.
8. Do not try to recharge batteries not intended to be recharged; they can overheat,
rupture and leak. (Follow battery manufacturer's directions).
9. Only an adult should replace the batteries.
STANDBY MODE
Standby Mode is when the unit is first plugged into an AC power source (display
flashing) or after all the settings has been made and the time is showing on the display.
Standby mode is also enabled when the Radio/AUX are off, no buttons are pressed
and no alarms are sounding.
CLOCK SETTING
The LED DISPLAY (#10) will be flashing when the unit is plugged in for the first time.
The unit is now in
standby mode.
Setting the Time:
1. In standby mode, press and hold the TIME / MEMORY
BUTTON (#4) until the hour digits of the clock display
begin to flash.
2. Repeatedly tap the TUNE - / BUTTON (#6) or
TUNE + / BUTTON (#7) to set the hour. Press and
hold the button for fast reverse/advance setting. Make
sure the correct AM or PM time is selected when setting the hour.
Note:
The PM INDICATOR (#9) is located in the upper left part of the display.
The PM INDICATOR (#9) will light when the hour digits selected are for PM time.
The PM INDICATOR (#9) will be off when the hour digits selected are for AM time.
3. Press the TIME / MEMORY BUTTON (#4) to confirm
the hour setting, the minute digits will flash to prompt for
input
.
4. Repeatedly tap the TUNE - / BUTTON (#6) or
TUNE + / BUTTON (#7) to set the minute. Press
and hold the button for fast reverse/advance setting.
5. Tap the TIME / MEMORY BUTTON (#4) to confirm and complete the setting. The
display will stop flash ing.
Note:
The unit will automatically save the settings and exit the time set mode if you do not
press any buttons within 10 seconds.