- 14 -
reception.
NOTE:
Automatic tuning depends on the signal strength of the broadcasting station, so weak
stations may be skipped. You can manually tune to find the weak stations if a station gets
skipped. With strong signals, the tuner may stop before it reaches the actual broadcast
frequency, so you may need to manually tune for the best reception.
PRESET RADIO STATIONS BY MANUALLY
1) Press the STANDBY Button on main unit or remote control to turn on the unit.
2) Rotate the SOURCE Button on main unit or remote control to select FM/AM radio mode.
3) Tune to the desired radio station either by “manually” or “automatically” tuning method.
4) Touch the
PROG./SET Button on main unit
﹥2 seconds,
the next available preset
memory number will be shown in display and flashing (Note:”P01” will blink in the display
if you are programming preset for first time).
5) Rotate the SOURCE Button change to the desired memory number(for example P01/P02…).
6) Press the SOURCE Button to confirm the setting.
7) Repeat above steps 3 - 6 to preset up to 20 FM/AM stations
PRESET RADIO STATIONS BY AUTOMATICALLY :
Touch the AUTO/SCAN Button on main unit to start auto scan and preset programming, touch
again to stop auto scan radio stations.
•
start from start of FM 88MHz/AM 530KHz.
•
after a station is tuned, preset all stations from P01.
•
stop and go to P01 if :
1)
finish searching for whole band FM 88 – 108MHz /AM 530-1710KHz
2)
all preset stations (total 20 presets for this model) are programmed. No more space for
further station to be saved.
•
If no any station can be found, stop at FM 88MHz
RECALLING PRESET MEMORY CHANNELS
In radio mode, recall the pre-set channels by touch the
or
Button on main unit or remote
controller.
NOTE:
The clock and FM radio station presets will need to be reset if the power is interrupted or in
the event of a power outage. “12:00”or“24:00” will appear on the display to notify you that
the power was interrupted and the clock will need to be reset. Please follow steps 1-7 above
to resave the preset stations.
SETTING THE CLOCK
After plugging in the AC power, “12:00”or“24:00” will appear on the LCD display.
1) In Power Off (Standby) mode, press the TIME Button on main unit. The “24H” format will
show in display and digit “24” will keep blinking.
2) Rotate the SOURCE Button on main unit to select 24H or 12H format if necessary.
Otherwise press the SOURCE Button to confirm clock format and enter clock setup mode,
Hour digits will be flashing.
3) Rotate the SOURCE Button on main unit to adjust the hour.
4) Press the SOURCE Button to confirm the hour setting, the minute digits will flash to prompt