E-19
Press
DIMMER Button
on remote control repeatedly to adjust the display brightness level.
Medium
DIM
Bright
If the system does not respond or has erratic operation, you may have experienced an
electrostatic discharge (ESD) or a power surge that triggered the internal MCU to shut
down automatically. If this occurs, unplug the AC-DC adaptor from the AC outlet and wait
for 60 seconds, then plug the AC-DC adaptor back into the AC outlet. The unit is now reset.
You need to reset the clock and alarm after reset.
This unit features a 1 AMP (1000mA) USB charging port for charging your portable device
(iPod, iPhone, Android phone, etc.) when unit in
STANDBY and USB MODE.
Use with the USB charging cable that came with your device (not supplied) for charging.
1.
Turn the unit to STANDBY or USB mode. Plug one end of the USB cable (not
included) into the
USB Charging Port
located on the front panel of the unit. Plug the
other end of the cord into the device you wish to charge.
2.
Observe the battery charge indicator on your device to make sure the charging
process starts normally.
3.
Unplug the cable when your device is fully charged.
CAUTION:
USB charging works in Standby and USB mode. Before charging, please refer to the user
manual of the device you wish to charge to make sure the charging current requested does
not exceed 1.0A (1000mA). Overloading the charging circuit may damage the unit
permanently and void the warranty.
1.
The USB charging port of this unit supplies a DC 5V output at 1000 mA maximum
current to charge your smart phone or portable device battery and it cannot support
any other voltage range.
2.
Make sure the device you want to charge has a battery charge rating of DC 5V only.
3.
The USB port of this unit is designed for smart phone or portable device battery
charging only and it cannot support data transfer or connect to computer.
4.
Do not connect the USB port of this unit to other external power charger
USB ports, it
may damage both units and void the warranty.
Note:
1.) Some smart phones and portable devices use proprietary USB connections and
circuitry, so they may not charge when plugged into the USB port. Please refer to your
device user manual before you attempt to charge them.
2.) It is normal if the unit gets warm while the USB port is in use and charging your smart
phone or portable device.
3.) Do not charge your smart phone over 12 hours continuously. Disconnect your smart
phone or other portable device from the USB cord once it is fully charged.
ADJUST DISPLAY BRIGHTNESS (REMOTE CONTROL ONLY)
RESETTING THE UNIT
CHARGING YOUR SMART PHONE OR PORTABLE DEVICE
