E-12
Note:
The SNOOZE feature is only active for 60 minutes after the original alarm time.
You can press
SNOOZE button
again multiple times as long as it’s within that 60 minutes
active period, and as long as a minimum of
10
minutes remain. Once the 60 minutes
expires, the alarm will stop
until
next day.
1. Tap the
POWER/STANDBY Button
on main unit or remote control to turn on the
unit.
2. Tap the
MODE Button
on main unit or remote control to select FM mode. The FM
frequency appear in display.
3. To manual tune to a specific radio station, tap the
/
Button
on either main unit or
remote control repeatedly. Use the manual tuning method to tune in weaker stations
that are bypassed during automatic tuning.
4. To automatically tune to the next available radio station, press and hold
/
Button
on main unit or remote control for 1-2 seconds until frequency readout on the display
begins to scan and then release the button. The tuner will stop scanning when it
receives the next broadcasting station of adequate signal strength.
5. Rotate the
VOLUME
knob on main unit or press the
VOLUME
/
Button
on
remote control to adjust the volume control to the desired volume level.
FM/ FM Stereo reception
When listening to the FM radio, press the
Button
on main unit or remote control to
switch between stereo mode (ST) and mono mode (MONO). It is preferable to receive the
program in mono when you are receiving a weak station.
HINTS FOR BEST RECEPTION:
For best FM reception, the FM lead wire antenna located on the back of the unit should be
fully unwrapped and extended.
NOTE:
Automatic tuning depends on the signal strength of the broadcasting station, so
weak stations may be skipped. You can manually tune to find the weak stations if a station
gets skipped. With strong signals, the tuner may stop before it reaches the actual
broadcast frequency, so you may need to manually tune for the best reception.
PRESET RADIO STATIONS
1. Tap the
POWER/STANDBY Button
on main unit or remote control to turn on the unit.
2. Tap the
MODE Button
on main unit or remote control to select FM mode.
3. Press and hold
Button
on main unit or
SCAN Button
remote control to perform auto
search and program preset channels.
“PROG” appears in display and flashing. Auto
searching and programming will stop at PROG 01
after scan finished, “PROG” shows in
display steadily.
Note:
If the channels stored during the auto search but programmed preset are not your
favorites, use the method below for the manually saving radio presets.
4. Tune to the desired radio station either by “manually” or “automatically” tuning method.
►
II
LISTENING TO RADIO
