E-12
RADIO OPERATION
1. Tap the
STANDBY-ON
Button
on main unit or remote control to turn on the unit.
2. Tap the
FUNCTION Button
on main unit or remote control to select AM/FM mode, the FM
radio frequency appear in display.
3. To manually tune to a specific radio station, tap the
or
Button
on either main unit or
remote control repeatedly. Use the manual tuning method to tune in weaker stations that are
bypassed during Automatic Tuning.
4. To automatically tune to the next available radio station, press and hold the
or
Button
on main unit or remote control for 1-2 seconds until frequency readout on the display begins to
scan and then release the button. The tuner will stop scanning when it receives the next
broadcasting station of adequate signal strength.
5. Press the volume control
/– Button
on main unit or remote control to adjust the
volume control to the desired volume level.
FM & FM-Stereo reception
-
When listening to the FM radio, press the
ST./MONO Button
on remote control to switch
between stereo mode and mono mode. The FM stereo icon “ST” will appear on the display if
unit is in stereo mode. It is preferable to receive the program in mono when you are receiving a
weak station.
HINTS FOR BEST RECEPTION:
AM -
The AM antenna is located inside the cabinet of the unit. If AM reception is weak,
change the position of unit until the internal antenna picks up the strongest signal.
FM -
For best FM reception, the FM lead wire antenna located on the back of the unit
should be fully unwrapped and extended.
NOTE:
Automatic tuning depends on the signal strength of the broadcasting station, so weak
stations may be skipped. You can manually tune to find the weak stations if a station gets skipped.
With strong signals, the tuner may stop before it reaches the actual broadcast frequency, so you
may need to manually tune for the best reception.
PRESET RADIO STATIONS
1. Press the
STANDBY-ON Button
on main unit or remote control to turn on the unit.
2. Tap the
FUNCTION Button
on main unit or remote control to select FM radio mode.
3. Tune to the desired radio station either by “manually” or “automatically” tuning method.
4. Tap the
PROG/TIME.SET.Button
on remote control, the next available preset memory
number flash in the LED display. (Note:”P01” will blink in the display if you are programming
preset for first time)
5. Tap the
PRESET
or
Button
on remote control to select the preset number you want to
assign the station to.
6. Tap the
PROG/TIME.SET.Button
on remote control to confirm the setting.
7. Repeat above steps 4 - 8 to preset up to 20 FM and 20 AM stations.
RECALLING PRESET MEMORY CHANNELS
In radio mode, recall the pre-set channels by pressing the
PRESET
or
Button
on remote
control repeatedly.
NOTE:
The clock and FM radio station presets will need to be reset if the power is interrupted or in the
event of a power outage. “12:00” will appear and start blinking on the LCD display to notify you
that the power was interrupted and the clock will need to be reset. Please follow steps 1-7
above to resave the preset stations.
Содержание JBS-230
Страница 8: ...E 7 LOCATION OF CONTROLS MAIN UNIT...
