Jensen CD615X, Инструкции по установке

Страница: 8 / 13

8
®
CD615X
✓
Testing
Before you finish the installation, you should do the following tests to make sure the wiring is correct
and everything is operating properly.
Test Antenna Connection
1. Press >> or << . The radio should tune to a
nearby station. If not, check antenna
connection.
Test Memory Wiring
Test Power Wiring
1. Turn ignition switch on. The display should
light and show 12:00. If not, check the
electrical connection at the yellow and red
wires.
Reconnect Battery
When wiring is complete,
reconnect the battery
negative terminal.
+
–
1. With the radio playing, hold
button 1 for five seconds. The
radio will beep. You just stored
the current station in memory.
2. Press
VOL
to increase
volume until you can
hear the radio playing.
2. Press PWR to turn the radio on. You will
see the radio display. If not, check electri-
cal connections to the red and yellow
wires.
3. If equipped, the power antenna should
also operate. If not, check electrical
connections to the dark blue wire.
Set the Clock
1. Press and hold DISP button
for 3 seconds until display
flashes.
2. Within 3 seconds, press >> to
change minutes, << to change
hours.
1 1
4
2
3
1
VOL
VOL
VOL
VOL
1
VOL
VOL
VOL
VOL
2 VOL
VOL
or
2. Turn the key off, then turn the
key on again.
3. Press >> or << up or down.
The radio will select a different
station.
4. Press button 1 again. It should
return to the station that was
playing before (step 1). If not,
make sure the yellow wire is
connected properly.
3 Sec
5 Sec
DISP
1
2
0
1
2
3
VOL
VOL
VOL
VOL
M
H
PROGRAM RANDOM SCAN REPEAT BASS
PROGRAM RANDOM SCAN REPEAT BASS
5293_Ein.p65 4/10/99, 11:19 PM 8