background image

15A

iPod

+

BT1613

PS/AS

BT1613 

What’s in the Box

BT1613 Head Unit
Cosmetic Trim Ring
Wiring Harness Power/Speaker
Mounting Hardware 
Remote Control
jLink iPod Cable
3.5mm Media Cable
Owners Manual
Installation Guide









Tools and Supplies

You will need these tools and supplies to install your 
BT1613:

Torx type, fl at-head and Philips screwdrivers
Wire cutters and strippers
Tools to remove existing radio (screwdriver, 
socket wrench set or other tools)
Electrical tape
Crimping tool
Volt meter/test light
Crimp connections
18 gauge wire for power connections
16 – 18 gauge speaker wire








Installation Guide

WARNING! Never install this unit where operation and viewing could interfere with safe driving 
conditions. 

Wiring Diagram

IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have 
the installation handled by an experienced technician.

Need Help? 

For technical assistance, call the Jensen customer support line at 1-800-323-4815.

NOTE: When replacing a 
fuse, make sure the new 
fuse is the correct type 
and amperage. Using 
an incorrect fuse could 
damage the radio. This 
head unit uses one 15 
amp fuse located below 
the wiring connector (15 
amp fast blow ATO).

Power Antenna 

(dark blue wire) Connect 

to the power antenna or an amplifi er. If not 
used, tape the bare end of wire.

Accessory/Ignition

 (red wire) 

Connect to the existing radio wire or radio 
fuse.

Ground

 (black wire)

Connect to the ground terminal or a 
clean, unpainted part of the chassis.

Memory/Battery

 (yellow wire) 

Connect to the battery or to a 12 volt 
power source that is always live. The radio 
will not work if this wire is not connected.

Antenna 

RCA Outputs to Amplifi er

Left Front Speaker

Right Front Speaker

Left Rear Speaker

Right Rear Speaker

Dark Blue

Black

Yellow

Red

Grey

Grey/Black (-)

Grey (+)

White/Black (-)

White (+)

Violet/Black (-)

Violet (+)

Green/Black (-)

Green (+)

15 Amp Fuse

SERIES

Subwoofer 
Output

iPod/jLink connector

 

Use this 8-pin DIN socket to 
connect your jLink iPod cable.

jLink 
iPod Cable

Отзывы: