4
WALL PLATE INSTALLATION
1.
The wall plate/power supply assembly may be mounted in most electrical outlet/switch boxes. The
plate can also be mounted without an electrical box. This mounting method requires a hole 2.75” x
2.0”. Route 2 16AWG wires to this hole from the 12VDC source. Also route all coax cables to this
hole. See Figure 5.
2.
Connect all coax cables to the appropriate wall plate pigtails. Each pigtail has a label for
identification. Connect the cable from the roof antenna to the “ANTENNA IN”. Connect the “TV2
OUT to TV input. “RADIO OUT” goes to the input of the AM/FM radio. “CABLE IN” connects to
the Park Cable Input. See Figure 6. (
Do Not Over tighten
)
3.
After connecting all coax cables, c12VDC wire to the + male spade terminal on the circuit
board (marked with a red dot) using a ¼” Insulated Female Spade Terminal. Then connect the
ground wire (marked with a black dot) using the same type terminal. See Figure 6.
6.
Install the wall plate using a two #6 Flat Head screws.
7. Connect main TV to the TV1 output on the front of the wall plate.
2.0"
2 .7 5"
IN T ER IO R W ALL
R O U T E ALL P O W ER /G R O U N D W IR ES
A N D C O A X C A BLES T H R O U G H T H IS H O LE
F IG U R E 5
* Recommendation of RG-6U cable type with a maximum length of
10 feet between Plate and Antenna.
A NT ENNA
IN
TV 2
O UT
RA DIO
OUT
CAB LE
IN
To Park C able
To AM/FM Radio
To Antenna
To Second TV
FIGU RE 6
+12VD C INPUT
0V GR OUND INPUT
#6 FLAT HEAD SC REW
FIGURE 7
