Jensen A540 DiXL V-2203, Руководство по эксплуатации

Страница: 30 / 110

5
Knives and counter-knife
Observe to re-tighten screws by using the safety discs. The machine is equipped with
a simply exchangeable and reversible counter-knife in tapered execution. It has two
sharp edges. Avoid from dirt when disassemble – mounting the counter-knife, clean
the surfaces from dirt and chips.
Attention:
Use only spare parts origin JENSEN. No warranty in case of using other
products. In case of spare part order always mention the number of this machine.
Technical Specifications for woodchippers
Maximum wood diameter: (depending on wood and engine)
A141 = 26cm A041 = 30cm
A231 = 24cm A240 = 24cm
A328 = 20cm A340 = 20cm
A425 = 18cm A540 = 19cm
A430 = 18cm A428 = 18cm
A528 = 15cm A530 = 15cm
A518 = 12cm A521 = 13cm
On heavy feed please watch the rpm of the chipper-disk!
In case the rpm drops, you should disengage the hydraulic feed rollers and do not
engage again before the machine is back to the full rpm.
Necessary power:
with 2 knife and mixed bushes you need about 25 KW.
The power you really need depends on the sorting and the kind of the wood, the
speed of feed and the number of knifes in your machine.
Caution!
Knife-screws and all screw on the transportation-axle should be controlled
regularly and tightened following the table:
Forces for bolts and nuts:
Size
Nm
Tightening
torque
8,8
class
Nm
Tightening
torque
10,9
class
M6 10
9,5-10,4
14,5
14,0-15,3
M8 25
23,1-25,3
35
34,0-37,2
M10 49 46-51 72 68-75
M12 86 80-87 125 117-128
M16 210 194-214 310 285-314
M20 410 392-431 610 558-615
M24 710 675-743 1050 961-1059
¾“ 410
410