Jensen A041 ZKX, Руководство по эксплуатации

Страница: 11 / 41

7. Pay attention to the sliding clutch in the Cardan shaft and ensure that it is fully
covered by the safety feature (machine and tractor) The covering of the safety
features must be at least 50mm in total!
8. Before turning on the PTO make sure that its high rotation speed power of the
propulsion machine is equal to the permissible rotation speed of the Wood
chipper!
9. Before turning on the PTO take care that no one is in close enough proximity
of the machine to get hurt!
10. When working with the PTO allow no one to stay in the turning area of the
PTO shaft or the Cardan shaft!
11. After switching off the PTO it can continue to rotate. During this time do not
step too close to the machine. Only resume work when it is totally still!
12. When turning the machine, ensure that the cardan shaft is suspended in the
preparatory position!
13. If there are any blockages in the Cardan Shaft remove them immediately
before you recommence work!
Working with the Wood Chipper
1. Study the safety measures for the smooth operation of all the functions!
2. When in use, the Wood chipper must be on a flat and firm area!
3. Materials in the entrance, the cords and rollers for example, cannot be made
to be fully safe because of their functions; therefore, during the running of
these moving parts it is necessary to have enough safety precautions!
Respect the other parts as well as they may also be not completely safe!
4. Never leave the Wood chipper unattended when in use!
5. Only operate the machine in good light and good visibility!
6. Do not place hands in the funnel – rotating pieces!
7. If someone climbs too far into the machine, the control bar should be pulled to
stop the machine immediately
.
8. The machine must only be operated when the chimney is fixed!
9. Put in the waste reeds and litter so that it is not facing anyone and no one is in
danger of being hurt by flying chopped-up pieces of wood!
10. Only deposit the wood into safe places!
11. Do not exceed the allowed wood thickness!
12. Only remove the surplus pieces etc.. with help and when the machine is
switched off (wood pieces and similar)!
Tilting Container
1. Before commencing any maintenance work lower the container, turn down the
water pressure and ensure that the machine is not able to start up by accident!
2. It is only possible to raise the containers when the machine is coupled with
something else otherwise there is a danger of it falling over!
3. To go beneath the raised container is prohibited in accordance with safety
guidelines!
4. When emptying the containers no one is permitted to remain in the work area.
Never walk under elevated loads!
5. When emptying the machine full of wood, it should be on stable ground so that
it is not able to fall over!
6. There is a danger of the elevated containers tipping over!
7. When the containers are raised, beware of hanging wires etc!