25
3. Using a
⁵⁄₃₂
" Allen wrench, tighten the door stop pin.
Complete Installation
1. Use the installation block to measure the gaps between the
panels and adjacent cabinets.
■
Custom wood overlay panels may be made with a
³⁄₈
"
(0.95 cm) or
¹⁄₈
"
(0.32 cm) gap between the panel and
cabinets and a
¹⁄₈
"
(0.32 cm) gap between the freezer and
refrigerator door(s) and the door(s) and top grille.
■
All purchased panel kits require a
³⁄₈
" (0.95 cm) gap
between the panel and the cabinets and a
¹⁄₈
"
(0.32 cm)
gap between the freezer and refrigerator door(s), and the
door(s) and top grille.
2. Adjust the panel to achieve the required spacing, or to align.
IMPORTANT: If adjustments are needed, adjust the panel not
the door. Adjust left to right in the mounting bracket before
using the pins to adjust the panel up and down or at an angle.
■
Slide the panel from side to side in the keyhole slot.
■
Use an Allen wrench to raise or lower the adjustment pins
which allows the door panel to swivel.
3. Predrill
¹⁄₈
" pilot holes in the door panel(s) through the open
holes in both the bottom and top hinges.
4. Using the slotted hex head screws (provided with refrigerator),
attach the top and bottom hinges to the door panels. Fully
tighten all door panel screws.
NOTE: For 36" models, there is an additional bracket at the
top to fasten the panel to the door. Insert the screws through
the bracket into the door panel.
5. Using slotted hex head screws (provided with refrigerator) for
each side, attach the door panels to the hinge-side door trims.
6. Using Phillips head flat screws (provided with refrigerator),
install the handle side door trim.
7. Completely tighten the screws attaching the mounting
brackets, located at the bottom of the doors, to the panels.
8. Reinstall the top door trim and hinge cover.
9. Snap the adjustment pin cover (provided with refrigerator) into
place.
10. If necessary, adjust the drawer panel to align and fully tighten
all drawer panel screws.
A. Door stop pin hole
A. Adjacent cabinet
B. Installation block
C. Panel on door
A. Door panel
B. Panel top bracket
C. Adjustment pins
A
B
A
C
A
B
C
A. Top hinge
B. Panel top bracket
C. Holes for screws
D. Door adjustment pins
E. Holes for screws
(36" Models only)
A. Drawer overlay panel
B. Drawer panel bracket
B
A
D
C
E
A
B
