Jenn-Air W10201609B, Инструкция по установке, эксплуатации и уходу, Страница: 12 / 40

12
6. Install blower motor and mounting bracket assembly to the
bracket just below the downdraft tower motor. The blower
exhaust opening should fit through the hole in the large cover
plate on the opposite side of the vent chamber where the
small cover plate was removed. Replace the 2 blower motor
mounting bracket screws and tighten.
7. Plug in the wire connector to the blower motor.
8. Place the vent extension for the 6" diameter venting over the
vent exhaust and screw into place using the 4 screws.
9. Replace the vent box over the blower motor.
10. Place the bottom tab of the blower box into the bottom
mounting channel.
11. Tilt blower box top tab so it is flush with the vent box panel
and position it under the top mounting bracket.
12. Slide bracket into the “Z” slots.
13. Tighten the 2 hex/slotted head screws to secure.
14. Place the small vent cover over the hole in the vent box and
secure in place with the 4 screws.
A. Downdraft tower motor
B. Large cover plate
C. Blower exhaust opening
A. Blower motor
B. Wire connector
A. Vent extension screws (4)
A
B
C
A
B
A
A
A. Blower motor
B. Vent box
A. Blower box
B. Bottom mounting channel
A
B
A
B