12
8.
Turn the control knob to LO and using a butane extension
lighter, light the burner.
9.
Remove the control knob.
10.
Use a
¹⁄₈
" x 4¼" flat-blade screwdriver to adjust the flame
height. Tighten screw to reduce flame height. Loosen screw
to increase flame height.
NOTE:
When you are converting to LP gas, the screw should
be tightened down completely on the single output valves.
The dual output valve should not be adjusted.
11.
When finished adjusting the flame height, put a control knob
back onto the valve stem and turn off the burner.
12.
Remove the control knob.
13.
Replace the round gasket.
14.
Repeat steps 6 through 13 for any other burners that need
adjustment.
15.
Lift up on the control console and set it back into place. For a
proper fit, the flange of the control console must hook over
the lip on the front of the range cooktop.
16.
Check that the control console is flush with the top edge of
the range.
17.
Replace the 2 screws on each side of the control console.
18.
Replace the control knobs.
19.
Replace burner grates.
20.
Test the flame by turning the control from LO to HI, checking
the flame at each setting.
Reinstall Kick Plate
1.
Align shoulder screw mounting holes with shoulder screws on
range.
2.
Push kick plate down against front of range until the top
screw holes are aligned with the mounting holes on the front
of the range.
3.
Reattach screws to the top of the kick plate.
Complete Installation
1.
Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2.
Check that you have all of your tools.
3.
Dispose of/recycle all packaging materials.
4.
For oven use and cleaning, read the Use and Care Guide.
Check Operation of Oven Bake Burner(s)
1.
Remove the oven racks and bake burner cover and set them
aside on a covered surface.
2.
Start a Bake cycle. See the Use and Care Guide for operating
instructions.
The oven bake burner should light within 8 seconds. Under certain
conditions it may take the burner up to 60 seconds to light.
Electronic igniters are used to light the bake burners.
NOTE:
No adjustments can be made to the bake flames.
Check Operation of Oven Broil Burner
1.
Remove the oven racks and set them aside on a covered
surface.
2.
Start a Broil cycle. See the Use and Care Guide for operating
instructions.
The oven broil burner should light within 8 seconds. Under
certain conditions it may take the burner up to 60 seconds to
light.
Electronic igniters are used to light the broil burner.
NOTE:
No adjustments can be made to the broil flames.
If you need Assistance or Service:
Please reference the “Assistance or Service” section of the Use
and Care Guide or contact the dealer from whom you purchased
your range.
A. Single flame burner adjustment screw (on right side of valve)
B. Dual flame burner adjustment screw (on left side of valve)
A. Control console flange
B. Front lip of range cooktop
A. Flush with range top
A
B
A
B
A
A. Kick plate
B. Reattach these screws.
C. Top screw hole
D. Shoulder screw mounting hole
A
B
D
C
Содержание PRO-STYLE JGRP430W
Страница 33: ...33 Notes ...
Страница 67: ...67 ...