5
P
ROVIDE
C
ABINET
S
UPPORT
IMPORTANT:
When installed below a
single or double oven, check to be sure that
any oven supports above the cutout do not
obstruct the 23-1/2" required depth of the
warming drawer cutout.
A
NTI
-T
IP
B
RACE
Install a 2" x 4" or 2" x 2" anti tip brace 9"
above the runners and against the rear cabinet
wall no more than 23" back from the face to
the cabinet frame.
• An anti-tip brace must be installed to
prevent the drawer from tipping for-
ward when opened and loaded. Failure
to do so could result in personal injury.
• Before installing anti-tip brace, refer to
Wall Oven or Cooktop installation
instructions for proper clearance of
electrical conduit or power cord.
WARNING
•
A 2" minimum clearance between
oven and warming drawer cutouts
is required.
Additional clearance may
be required if 2" x 4" blocks are used to
support runners or solid floor of the
oven above.
• The warming drawer may be supported
by either a solid bottom, 2" x 4" or
2" x 2" runners.
• The support must be level and rigidly
mounted, flush with the bottom edge of
the cutout.
• There is no way to level the drawer once
it has been installed. Be sure supports are
level.
• The entire weight of the drawer is sup-
ported by the runners or solid floor.
They must be capable of supporting
150 lbs.
25"
30"
23
1
/
2
"
2" x 4" or equivalent runners
9"
2" x 4" or runners
or solid bottom
S
PECIFICATIONS AND
R
EQUIREMENTS
,
CONT
.
I
NSTALLING THE
D
RAWER
1.
Slide the left corner into opening and
push power cord into the hole leading to
the outlet location. Thread the cord
through as drawer is being pushed back
into the opening.
If the outlet is installed inside the open-
ing, plug the cord into the outlet. Coil
power cord and install it in the clip on
the right side of the unit. Make sure the
cord does not get trapped by the drawer.
NOTE:
Insure that the power cord
does not contact the hot surfaces on the
bottom of ovens, cooktops, or any other
appliance.
2.
Push the drawer back until the front
flange is flush to the cabinet front.
3.
Open the drawer fully.
4.
Drill pilot holes through the holes in the
overlapping frame, one on each corner.
5.
Drive wood screws provided into each
corner.
IMPORTANT:
Do not operate the
Warming Drawer if the decorative front kit
has not been installed.