12
6.
Push straight down on the overlay panel to secure
the overlay hooks to the drawer.
7.
Using the self-tap wood screws (two per drawer; one
in each corner of the drawers), attach the panel to the
drawer.
NOTE:
Do not put the screws removed in step 4 back on
the door.
8.
Once the overlay is securely attached to the drawer
with the two screws, put the gasket back in its place
by pressing it against the door until the gasket is even
and firmly secured.
LEVEL THE REFRIGERATOR DRAWERS
IMPORTANT:
Overlay Model—Be sure to install the custom overlay
drawer panels before leveling the refrigerator
drawers. See “Install Custom Overlay Panel.”
Before installing the refrigerator drawers, be sure that
the countertop is level.
If the countertop is not level, adjust the refrigerator
drawers’ leveling legs until the appliance is square
with the countertop. Be sure to maintain 3/8" (9.5
mm) minimum gap between the top of the drawer
and the countertop.
1.
Open the top drawer and place the level across the
top drawer as shown. Check the level from left to
right.
2.
Turn the leveling legs (front and back) until the top
drawer measures level from left to right.
3.
Remove the level and close the top drawer. Check
the gap between the top of the drawer and the
countertop. If the gap measures less than 3/8"
(9.5 mm) minimum, turn all four leveling bolts
equally to the left to raise the leveling legs
(this will
lower the appliance). Recheck the level.
4.
Open both drawers less than midway. Place the level
on
the side flange beside the drawers as shown. Turn
the front leveling bolts together in order to either
raise or lower the appliance until the sides of the
refrigerator drawers are plumb.
5.
Remove the level and close the drawers. Recheck
the gap between the top of the drawer and the
countertop. If the gap measures less than 3/8"
(9.5 mm), turn all four leveling bolts equally to raise
the leveling legs (this will lower the appliance).
Recheck the level.
NOTE:
Be sure to recheck the horizontal level of the
top drawer.
6.
Be sure all four levelers are on the floor and
supporting the full weight of the refrigerator drawers.
COMPLETE INSTALLATION
1.
Remove all boxes, parts packages and packing
materials from the interior of the refrigerator drawers.
2.
Remove the film.
3.
Clean the refrigerator drawers before use. Refer
"CARE AND CLEANING" section.
4.
The controls are preset at the factory to the
recommended settings. Be sure that the compressor
is operating properly and that all the lights are
working.
5.
If construction will continue after the refrigerator
drawers have been installed, turn OFF the power for
both drawers.
To get the most efficient use from your new refrigerator
drawers, read the “Refrigerator Drawers Use” section.
A. Check the level from left to right.
A. Check the level from front to back.
A
A
