Jenn-Air JS42NXFXDE, Руководство по установке

Страница: 9 / 72

9
■
A ½" (12.7 mm) hole for plumbing should be drilled on the floor
at least 6" (15.2 cm) from the right- or left-hand side cabinet
and should be no more than 1" (2.54 cm) away from the back
wall. See “Connect the Water Supply.”
■
The water supply connection is made at the front of the
refrigerator.
■
If additional tubing is needed, use copper tubing and check
for leaks. Install the copper tubing only in areas where the
household temperatures will remain above freezing.
■
Do not use a piercing-type or
³⁄₁₆
" (4.76 mm) saddle valve
which reduces water flow and also clogs more easily.
NOTE: Your refrigerator dealer has a kit available with
a
¹⁄₄
" (6.35 mm) saddle-type shutoff valve, a union, and
copper tubing. Before purchasing, make sure a saddle-type
valve complies with your local plumbing codes.
Water Pressure
A cold water supply with water pressure between 30 and 120 psi
(207 and 827 kPa) is required to operate the water dispenser and
ice maker. If you have questions about your water pressure, call a
licensed, qualified plumber.
Reverse Osmosis Water Supply
IMPORTANT: The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet valve of the
refrigerator needs to be between 30 and 120 psi (207 and 827 kPa).
If a reverse osmosis water filtration system is connected to your
cold water supply, the water pressure to the reverse osmosis
system needs to be a minimum of 40 to 60 psi (276 to 414 kPa).
If the water pressure to the reverse osmosis system is less than
40 to 60 psi (276 to 414 kPa):
■
Check to see whether the sediment filter in the reverse osmosis
system is blocked. Replace the filter if necessary.
■
Allow the storage tank on the reverse osmosis system to refill
after heavy usage.
■
If your refrigerator has a water filter, it may further reduce the
water pressure when used in conjunction with a reverse
osmosis system. Remove the water filter cartridge.
If you have questions about your water pressure, call a licensed,
qualified plumber.
Product Dimensions
IMPORTANT:
■
The depth from the front face of the doors to the back of the
refrigerator cabinet is 24" (60.96 cm) without panels.
■
The power cord is 84" (213 cm) long.
■
The water supply connection is made at the bottom front of
the refrigerator.
Top View
Front View
■
Width dimensions were measured from hinge to hinge.
■
When leveling legs are fully extended to 1
¹⁄₄
" (3.2 cm) below
rollers, add 1
¹⁄₄
" (3.2 cm) to the height dimensions.
Model A
42 41
³⁄₄
" (106 cm)
48 47
³⁄₄
" (121.3 cm)
Model Width A (hinge edge to hinge edge)
42 41
³⁄₄
" (106 cm)
48 47
³⁄₄
" (121.3 cm)
A
24"
(61.0 cm)
*83
³⁄₈
"
(211.8 cm)
A
(see chart following)