8
8
8
8
8
8
Adjust the Doors
IMPORTANT:
■
Your refrigerator has two adjustable, front leveling screws –
one on each side of the refrigerator base. If your refrigerator
seems unsteady or you want the door to close easier, use the
instructions below.
■
Before moving the refrigerator, raise the leveling screws so
the front rollers are touching the floor.
1.
Remove the two screws fastening the base grille to the
cabinet, and set the screws aside. Grasp the grille and pull
it toward you.
2.
Raise or lower the cabinet.
Using a
¹⁄₄
" hex driver, turn the leveling screw on each side to
raise or lower that side of the refrigerator.
NOTE:
Having someone push against the top of the
refrigerator takes some weight off the leveling screws. This
makes it easier to turn the screws. It may take several turns of
the leveling screw to adjust the tilt of the refrigerator.
■
To raise, turn the leveling screw clockwise.
■
To lower, turn the leveling screw counterclockwise.
3.
Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both leveling screws clockwise. It may take several
more turns, and you should turn both screws the same
amount.
4.
Replace the base grille.
REFRIGERATOR USE
Opening and Closing Doors
There are two refrigerator compartment doors. The doors can
be opened and closed either separately or together.
There is a vertically-hinged seal on the left refrigerator door.
■
When the left-hand refrigerator door is opened, the hinged
seal automatically folds inward so that it is out of the way.
■
When both doors are closed, the hinged seal automatically
forms a seal between the two doors.
Wine Rack
(on some models)
Under one shelf, there are brackets installed to the supports (one
bracket on each support). The wine rack rests in these brackets.
To remove and replace the wine rack:
1.
Remove the wine rack by lifting it up off the brackets. Press
the right-hand side of the rack inward until it is free of its
bracket. Lower the right-hand side slightly and disengage
the left-hand side from its bracket.
2.
Replace the wine rack by inserting the left-hand side into its
bracket. Press inward on the right-hand side until it will slide
past the bracket edge and set it into its bracket.
A. Leveling screw
B. Front roller
A
¹⁄₄
"
B
A. Hinged seal
A
Содержание JFC2290REY
Страница 55: ...55 55 55 55 55 55 NOTES ...
