Jenn-Air JEF3115GS, Руководство по установке

Страница: 6 / 16

6
1.
Remove the foam strip from the hardware package. Remove
the backing from the foam strip.
For countertop installations: Apply the foam strip with the
adhesive side to the countertop within 1/16" (1.6 mm) of the
edge of the cutout, front, back, and sides.
For flush installations: Apply the foam strip with the
adhesive side to the bottom of the cutout recessed area.
Save the excess foam strip for use with the mounting
bridge kit.
NOTE: The foam strip helps keep the underside of the
cooktop frame free from debris and helps the cooktop
sit flat on uneven countertops. Do not silicone seal in place.
Install Cooktop
NOTE: For multi-unit installations, a mounting bridge kit is
required. See the “Tools and Parts” section.
1.
Install the cooktop into the countertop cutout by tilting one
end of the cooktop into the cutout, then lowering the other
end into the cutout.
NOTE:
Make sure that the front edge of the cooktop is
parallel to the front edge of the countertop. If repositioning
is needed, lift the entire cooktop up to avoid scratching the
countertop.
2.
Place drip tray in the well at the front of the griddle. Slide tray
toward the back until it stops.
3. Clean griddle before using. Refer to the Use and Care Guide.
Install cooktop into countertop
1.
Remove the two hold-down screws located in each side of
the cooktop burner box.
2. Attach the two hold-down brackets to the burner box.
3. Install the cooktop into the countertop cutout by tilting one
end of the cooktop into the cutout, then lowering the other
end into the cutout.
4.
Start the hold-down screws into the hold-down brackets.
5.
Center the cooktop in the opening and, using a wood block
between the screw and the countertop, moderately tighten
the screws to secure cooktop.
IMPORTANT:
Do not tighten screws directly against the
countertop.
Make Electrical Connection
This cooktop is manufactured with a frame-connected green or
bare ground wire. Connect the cooktop cable to the junction box
through the UL Listed or CSA Approved conduit connector.
Electrical Connection Options
If Your Home Has: And You Will Be
Connecting to:
Go to Section:
4-wire direct A fused disconnect
or circuit breaker
box
4-Wire Cable from
Power Supply to
4-Wire Cable from
Cooktop
(12.7 cm)
5"
3-wire direct A fused disconnect
or circuit breaker
box
3-Wire Cable from
Power Supply to
4-Wire Cable from
Cooktop
(8.9 cm)
3
¹⁄₂
"
A
B
C
D
A. Countertop
B. Foam strip C. Cutout
D. 1/16" (1.6 mm)
B
A
A. Griddle drip tray
B. Griddle
A
B
C
E
D
A. Countertop
B. Wood block
C. Hold-down screw
D. Hold-down bracket
E. Burner box
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.