Jenn-Air EDR3RXD1B, Инструкция по использованию и уходу

Страница: 24 / 48

24 | ASSISTANCE
PERFORMANCE DATA
SHEET
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.89
Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C).
Rated service capacity = 200 gallons (757 liters).
■
For installation, operation, and maintenance instructions please refer to
the Owners Manual.
■
It is important that operational, maintenance, and filter replacement
requirements be carried out for the product to perform as advertised.
Property damage can occur if all instructions are not followed.
■
The disposable cartridge must be changed at least every 6 months.
■
Use replacement filter part #EDR3RXD1/ EDR3RXD1B.
■
The filter monitor system measures the amount of water that passes
through the filter and alerts you when it is time to replace the filter. To
learn how to check the water filter status, see “Using the Controls” or
“Water Filtration System” in the User Instructions or User Guide.
■
After changing the water filter, flush the water system. See “Water and
Ice Dispensers” or “Water Dispenser” in the User Instructions or User
Guide.
■
These contaminants are not necessarily in your water supply. While
testing was performed under standard laboratory conditions, actual
performance may vary.
■
For installation, operation and maintenance instructions please refer
Owner’s Manual.
■
The product is for cold water use only.
■
The water system must be installed in compliance with state and local
laws and regulations.
■
Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
Systems certified for cyst reduction may be used on disinfected waters
that may contain filterable cysts. EPA Est. No. 082047-TWN-001.
■
Refer to the “Warranty” section (in the User Instructions or User Guide)
for the Manufacturer’s limited warranty, name and telephone number.
Application Guidelines/Water Supply Parameters
Water Supply Potable City or Well
Water Pressure 30 psi-120 psi (207 kPa - 827 kPa)
Water Temperature 33°F-100°F (0.6°C - 37.8°C)
Service Flow Rate 0.5 gpm (1.89 L/min) @ 60 psi (413.7 kPa)
*Class II particle size: >0.5 to 1 µm
†
Based on the use of Cryptosporidium parvum oocysts
††
Fibers greater than 10 um in length
®
NSF is a registered trademark of NSF International.