Minibeast Cordless
This document is protected by copyrights.
Copying, using, or distributing without permission of JEI Drilling & Cutting Solutions is prohibited.
7
22. Always secure the machine with a safety strap. Use the safety strap to attach
the machine to a stable structure. Put the strap through the hole in the machine
body. In the horizontal position, attach the strap to the carrying handle. Do not
put the strap into the buckle from the front.
23. Use eye and ear protection and protective clothing. Do not wear loose clothing.
24. We do not recommend working on workpieces thinner than 6 mm (0.24
″). The
clamping force depends on the workpiece thickness and is much lower for thin
plates.
25. Each time before you put the machine on the workpiece, grind the workpiece
with coarse-grained sandpaper. Make sure that the full bottom of the base
touches the surface.
26. Do not touch chips or moving parts. Do not let anything get caught in moving
parts.
27. After each use, clean the machine and the tool. Do not remove chips with your
bare hands.
28. Remove the battery before you do maintenance or install/remove parts.
29. Repair only in a service center appointed by the seller.
30. If the machine falls, is wet, or has any damage, stop the work, and immediately
send the machine to the service center for check and repair.
31. Do not leave the machine when it operates.
32. If you are not going to use the machine, remove the tool from the holder.
33. If you are not going to use the machine for an extended period, put anti-
corrosion material on the steel parts.
34. Use only original Promotech or CAS (Cordless Alliance System) batteries and
chargers with the following parameters:
Batteries: 18 V LiHD 4.0 Ah, 18 V LiHD 10.0 Ah
Chargers: ASC 145
35. Do not open the battery and do not short-circuit its contacts.
36. Do not allow the battery to be fully discharged. Do not leave the battery in the
machine.
37. Store the machine and battery in a safe and dry place. Do not store discharged
battery.
