This document is protected by copyrights.
Copying, using, or distributing without permission of Ansa Group Ltd is prohibited.
drill when using annular cutters). The tools are designed to evacuate chips when
drilling.
Correct Cutter Usage
IMPORTANT INFORMATION
Only use your Minibeast to cut through single layers of material when using standard annular
cutters.
Do not
attempt to cut through multiple layers/stacks/laminates of material with your Minibeast
magnetic drilling machine using standard annular cutter. Once the first plate has been drilled, the
centre slug will retain in the cutter. Attempting to continue the cutting process will result in cutter
breakage, or can cause the magnet to break away from the surface, resulting in injury. (Note
–
always secure the machine to the workpiece with the provided safety strap).
To achieve multiple layer cutting, please refer to JEI’s Multi Layer Cutter form, available for all
Turbo
™ types. This will allow the solid slugs to be retained in the cutter during the cut and be
safely ejected once the hole cutting process is completed. Please refer to your JEI distributor for
further details.
3.4 After the cut
1. After the cut, has finished, the slug should be expelled on the down stroke, if the
slug is not expelled after the cut, disconnect the machine from the power source
and remove the cutter from the arbor body, then expel the slug. (Caution: the
pilot should not be used to do this.