This document is protected by copyrights.
Copying, using, or distributing without permission of Ansa Group Ltd is prohibited.
•
Work piece is made of steel
•
Thickness of steel is at least (10mm)
•
Surface of Steel under the Magnet is flat
•
Wipe, brush or sand down clean surface where you intended do use the
drilling machine, so that you remove rust, paint, dirt etc which would reduce
adhesive power of the electromagnetic base.
•
Install Turbo-cutter in the machine before plugging it into mains, then plug in
and position where you wish to use it.
•
Place the machine so that the tool is over the centre of the hole you intend to
make and turn the Magnetic Base ON.
3.3 Ready to Make the Cut
1. Insert the annular cutter in to the machine arbor, lining up the flats on the cutter
shank drive with the set screws on the arbor. Secure the set screws making sure
the screws are recessed in Arbor body.
The surface you are working on should be clean and level, free from rust, scale,
dirt and chips.
2. When using the annular cutter arbor fill coolant reservoir with a water-soluble
coolant.
3. Position the Minibeast on the work piece.
4. Lower cutter / drill to surface of materiel. When using cutter tool holder, coolant
flow starts when pilot pin is depressed. Lifting pilot pin off work surface will stop
coolant flow.
5. Place the drilling machine on the work piece, with pilot pin over the centre of the
hole to be cut.
6. Move the rocker switch located on the panel to the ON position. The switch will
illuminate to indicate DC power is going to the magnet.
7. Depress motor ON switch to start drill.
8. To start a cut, apply pressure until the cutter has established an external grove.
Then apply steady pressure through the remainder of the cut (Note: Do not peck