8. Crossover circuit - Speaker connection
8.1. precable crossovers - see fig. page 11.
8.2. install crossover – without housing; covered with foamed material-
in the hollow space above the front subwoofer ( see fig.) . Check precise fit .
8.3. Insert subwoofer and midrange and connect all loudspeakers
with the included standart cables for subwoofer to the crossover circuit:
parallel wiring see diagram on page 11.
Notice:
You should check the polarity of all subwoofers
before connecting them to the crossover circuit
with a 9 volt battery:
pole of the crossover circuit input to of a 9 Volt battery
pole of the crossover circuit input to of a 9 Volt battery
All subwoofers must move uniformly!
Wrong polarity of a subwoofer can totally
equalize the bass sound!
8. Crossover circuit - Speaker connection
8.1. precable crossovers - see fig. page 11.
8.2. install crossover – without housing; covered with foamed material-
in the hollow space above the front subwoofer ( see fig.) . Check precise fit .
8.3. Insert subwoofer and midrange and connect all loudspeakers
with the included standart cables for subwoofer to the crossover circuit:
parallel wiring see diagram on page 11.
Notice:
You should check the polarity of all subwoofers
before connecting them to the crossover circuit
with a 9 volt battery:
pole of the crossover circuit input to of a 9 Volt battery
pole of the crossover circuit input to of a 9 Volt battery
All subwoofers must move uniformly!
Wrong polarity of a subwoofer can totally
equalize the bass sound!
75059 - Audi A 6 - models from 6’97
- 10 -
© JEHNERT SOUND DESIGN
75059 - Audi A 6 - models from 6’97
- 5-
© JEHNERT SOUND DESIGN
3 . Panel alignment
3.1. Place the door lining on a plane surface.
3.2. Dismount the loudspeakers attached to the panel for transport protection.
Retain the screws for later assembly.
3.3.
Place the panel without loudspeakers and grill on the door lining and align it:
Reference points for fitting:
Only precise alignment of the panel with the door
lining warrants optimal fit.
Reference line 1:
”nose”on the backside of the door build has to be aligned
directly to the notch under the arm rest
Reference line 2:
upper panel edge lines up directly underneath the arm rest
Reference line 3:
the lower edge of the panel is parallel to the lower
edge of the door lining
�
�
✚
✚
ref.point line 1:
”nose”on the backside of the door
build has to be aligned directly to
the notch under the arm rest
ref.point line 2:
upper panel edge lines up directly
underneath the arm rest
ref.point line 3:
lower edge of panel and
lower edge of door lining
are parallel
