JEHNERT Sound Design | Im Michelreis 14 | D-72124 Pliezhausen | Tel. 07127 / 93457-0 | Fax 07127 / 93457-10 | [email protected] | www.jehnert.de
Assembly instruction
Status: 02.11.2023
VW Bus T6
cab system 65400-2
Art. N0. 65400
3
2. crossover assembly
The radio must be removed to adapt the input of the crossover.
2.1 Use a plastic wedge to lever off the radio bezel (incl.
ventilation nozzles). lever off with a plastic wedge.
2.2 Remove the 4 Torx screws (TX20) underneath.
Pull out the radio and disconnect the quadlock connector.
2.5. lead the woofer cable to the woofer installation location
through the rubber grommet to the vehicle door.
2.6 Route the mid-range and tweeter cables under the dashboard to
the A-pillar.
2.4. connect speaker cables for tweeter, midrange and woofer to the
to the labeled crossover output (with 6.3mm
crimp connector), mark midrange and tweeter cables.
Wrap crossover with damping fl eece or similar, insert right and left
under the dashboard on the right and left side and make sure
and ensure a tight fi t (e.g. with cable ties).
Zur Vermeidung von Vibrationsgeräuschen alle Kabelstränge mit Isolierband o.ä. sichern.
2.3 Adapting the loudspeaker cable with the radio
(Radio connections: „Front left“ and „Front right“).
Route cable to crossover mounting location
right and left under the dashboard. Connect cable to
Connect crossover input.
