BATTERY CONNECTIONS
a) Positive (+) lead alligator clip/ring terminal of charger to positive (+) battery post.
b) Negative (-) lead alligator clip/ring terminal of charger to negative (-) battery post.
Note:
If the electrical connections are not correct, then POWER LIGHT will flash quickly.
CHARGING STATUS LIGHT (TWO-COLORED STATUS INDICATOR LIGHT)
- When the red light is on it indicates
that the battery is correctly connected and the Bank charger is charging it. The charger will deliver its full rated current
until this light turns from red to green.
When the battery is fully charged, the charging status indicator light will tum to green and the charger will switch to a
storage/maintenance charge mode. The charger will automatically monitor and maintain the battery with 0.8A charging
current.
OPERATING INSTRUCTIONS
Check polarity of battery posts. A positive (pos, p, +) battery post may have a larger diameter than a negative (neg, n, -)
post;
1. Connect the battery lead plastic plug to the charger / maintainer plastic plug.
2. Proceed to plug the AC power cord into a nearby 120V AC GFCL (Ground Fault Circuit Interrupter) protected outlet.
If needed, connect a heavy duty U.L. approved extension cord to the charger. After connecting the extension cord to
the charger, proceed to plug the extension cord to a nearby 120V AC GFCL (Ground Fault Circuit Interrupter) protected
outlet. The POWER ON indicator will tum RED.
3. Open all battery compartments and ventilate for at least 15 minutes before applying AC power to your charger. While
charging your batteries, make sure to keep your battery compartment open allowing for free air ventilation.
4. Follow battery manufacturer's recommendation for battery cell caps (loosen caps if applicable).
5. Connect the battery lead terminal rings or alligator clips directly to the corresponding battery posts. Position the RED
terminal ring or alligator clip on the POSITIVE post connector. Position the BLACK terminal ring or alligator clip on the
NEGATIVE post connector. Make sure all battery connections are tight and clean. The POWER ON indicator will tum
off. If the battery voltage is more than 7.5V, the charger will charge the batteries according to 12V mode, the 12V LED
LIGHT will turn RED. If the battery voltage is less than 7.5V, the charger will charge the batteries according to 6V
mode, the 6V LED LIGHT will turn RED.
6. The charger begins charging with 0.8A low current to recover the batteries automatically if the batteries are not full.
7. Observe the CHARGING STATUS LED LIGHT (TWO-COLORED STATUS INDICATOR LIGHT), when the red light
is on it indicates that the battery is correctly connected and the charger is charging it. The charger will deliver its full
rated current until this light tums from red to green. When the battery is fully charged, the CHARGING STATUS
INDICATOR LIGHT will turn to green and the charger will switch to a storage/maintenance charge mode. The charger
will automatically monitor and maintain the battery with 0.8A charging current.
8. When you are ready to use your vehicle, unplug the AC power cord or extension cord (if used) from the 120VAC
power outlet followed by unplugging your battery terminal lead from the charger.
1-800-345-4545 jegs.com
